Heating, Cooling & Indoor Air Quality in Boonville, IN

Performed comprehensive inspection of 9-year-old HVAC system due to homeowner's concerns about high energy usage. Conducted thorough examination of attic insulation, noting condition and coverage of fiberglass batting between floor joists. System was operational during service call; recommended maintenance procedures to optimize efficiency and reduce utility costs.

Completed annual planned maintenance on NSSU system with 20X20X5 filters. Performed level check on equipment and inspected control board circuitry and connections. System installed 9/12/25, first visit of annual maintenance cycle; customer declined renewal at this time.

Conducted a comprehensive HVAC replacement estimate for an inoperative system. Inspection revealed an aging outdoor unit with significant debris accumulation around the base and examined the attic ductwork system which showed multiple flexible ducts requiring evaluation. Customer was unavailable until 3:30pm, limiting immediate consultation on replacement options.

Performed routine Gold Level maintenance on two HVAC systems (both approximately 13 years old) during our 21st scheduled visit. Replaced filters (28x36x1 and 20x25x5) and documented significant frost/ice accumulation on evaporator coils and refrigerant lines in one unit. Recommended immediate follow-up service to address refrigerant flow issues and potential restriction in the system before component damage occurs.

Performed Gold Level maintenance on 19-year-old HVAC system. Inspected evaporator coils showing signs of oxidation and minor corrosion at connection points, particularly at the brass valve fitting. Noted significant dust and debris accumulation in ductwork and on insulated pipes, recommending thorough cleaning before next scheduled maintenance in September 2025.

Performed annual planned maintenance on Lennox HVAC system (installed 8/15/25). Checked system temperature readings (183°F recorded), inspected unit integrity, and replaced 16x25x5 filters. System functioning within normal parameters; customer advised that renewal is not required at this time.

Performed platinum level maintenance on a 4-year-old HVAC system. Inspected and replaced the 20x25x4 MERV 10 media filter and 20x25x1 polarized filter. System is functioning properly with no issues detected.

Performed Platinum Level maintenance on an 8-year-old HVAC system. Inspected and replaced 20x20x5 filter during first annual visit. Examined electrical connections and refrigerant lines, noting debris accumulation under unit structure requiring cleanup for proper airflow and system efficiency.

Performed warranty service call on a Lennox high-wall heat pump indoor unit (Model MMD63235-1P). Conducted leak search on the system and documented required replacement parts. System requires follow-up service with parts to complete the warranty repair.

Successfully installed an Eemax tankless water heater unit within a wooden cabinet enclosure. Completed all necessary plumbing connections including PVC piping and brass valves, ensuring proper fitting and secure mounting. System was tested and confirmed to be functioning correctly with temperature controls properly calibrated.

Conducted comprehensive inspection of residential plumbing system in crawlspace area, documenting PVC supply and drainage infrastructure. Identified aging pipes with accumulated grime and assessed structural supports connecting to floor joists. Estimate prepared for necessary repairs to maintain system integrity and prevent potential future failures.

Successfully completed installation of a GREEN 17 SEER 97% efficiency complete HVAC system, including a high-efficiency furnace with PVC venting in the basement utility area and an outdoor condensing unit mounted on a concrete pad with proper electrical connections. All ductwork was properly installed and insulated, with the system fully tested and operational.

Performed scheduled second annual maintenance visit on 7-year-old Gold Level HVAC system. Inspected electrical connections and wiring, noting proper terminations with no signs of overheating or loose connections. Examined and documented significant dust accumulation in ductwork that could restrict airflow; recommended professional duct cleaning service to improve system efficiency and indoor air quality. Replaced 16x25x5 air filter as part of routine maintenance protocol.

Performed comprehensive assessment of existing HVAC system, including inspection of aging Trane Weathertron analog thermostat and outdoor unit showing significant weathering with visible rust formation. Provided customer with replacement options for complete system upgrade, recommending high-efficiency equipment to replace the deteriorated outdoor condensing unit and modernize outdated control interface.

Responded to no-heat call for 15-year-old Lennox system (Model MNG32V5-125-1, Serial 5800B41474). Diagnosed faulty induction motor that was overheating and causing system shutdown; customer had correctly identified the issue as the motor was extremely hot to touch. Replaced motor and verified proper system operation with normal airflow through vents.

Performed annual planned maintenance on HVAC system installed 9/5/25. Inspected electrical components including circuit board connections and terminal points (W1, W2, C). Verified system level and proper mounting of equipment. Replaced 16x25x5 filter as part of standard maintenance protocol. Documentation completed with supporting photographs of internal components and installation positioning.

Completed scheduled 6-month maintenance service on mini-split system (1st visit-NSSU). Performed leveling check on ventilation registers and conducted temperature measurements with digital probe, confirming proper system operation at 29 degrees. All components inspected and functioning within normal parameters.

Replaced faulty water shutoff valve in toilet tank that was continuously running. Installed complete new flush kit, addressing mineral buildup and sediment accumulation in the tank. All components now functioning properly with proper water level restored.

Performed warranty replacement of existing tankless water heater. Installed new unit on exterior wall with proper PVC venting and electrical connections. Internal inspection of previous unit revealed significant corrosion and rust damage on the bottom surface around drain points, likely contributing to failure. All connections were tested and system is functioning properly with no leaks detected.

Conducted an assessment of current HVAC system for potential replacement. Existing installation includes an older Trane XL 78 furnace positioned on concrete flooring in utility area with visible ductwork connections secured with metallic tape. System evaluation also included examination of adjacent water heater with pressure relief valve and associated plumbing connections. Photos documented the current equipment configuration and basement mechanical room layout for replacement planning purposes.