Heating, Cooling & Indoor Air Quality in Boonville, IN

Performed scheduled platinum-level maintenance on HVAC system, including replacement of 20x25x5 filter which was 5 years old and due for monthly service. Inspected water heater connections and exhaust venting for proper installation. Cleaned blower wheel assembly to remove accumulated dust and debris, ensuring optimal system performance and airflow.

Performed routine maintenance inspection on customer's mini-split system. Examined wall-mounted indoor unit and ceiling air register for proper operation. Reviewed and verified BAM washable filters are in good condition; no service required at this time.

Completed installation of a 3.5-ton 14 SEER/9.7 HSPF upflow/horizontal split system in a new construction residence. Unit was properly mounted in the mechanical closet with required insulation and drainage line was routed along the exterior of the building per specifications. Site was left in clean condition with all equipment operational.

Completed annual planned maintenance on HVAC system as part of Platinum Level service agreement (second visit this year). Inspected system operation, verified thermostat functionality with proper temperature control at 72°F, and examined water heater for any issues. Replaced 16x20x5 air filter. Noted service agreement requires renewal.

Completed installation of a 3-ton Lennox HVAC complete system in a downstairs/basement location. Installed new outdoor condenser unit on concrete pad with proper line connections to the home. Set up interior furnace unit with PVC ventilation pipes and connected to existing ductwork in the utility area.

Performed scheduled maintenance on wall-mounted inverter air conditioning unit in utility room. Inspected unit, cleaned filters, and verified proper operation. System is functioning within normal parameters with no issues identified.

Performed scheduled Platinum Level maintenance on 15-year-old HVAC system. Accessed internal components, inspected electrical connections and circuit boards using Fieldpiece multimeter. Replaced 16x25x5 filter as part of regular maintenance protocol.

Completed scheduled maintenance on single HVAC system with washable filters. Performed comprehensive inspection of furnace interior components, including examination of gas valve, motor assembly, control boards, and electrical connections. All wiring harnesses and electronic components were verified to be properly secured and functioning correctly.

Completed scheduled maintenance visit (2nd of 3) for HVAC system. Replaced 16x25x5 air filter as part of regular 3-year maintenance plan. Noted corrosion on water pipe connection near heating unit which should be monitored but requires no immediate action.

Completed scheduled gold maintenance service on a 7-year-old residential HVAC system. Inspected outdoor unit mounted on concrete pad adjacent to home's brick exterior. System appears to be functioning properly with no visible issues noted during this maintenance visit.

Performed monthly maintenance service on 3-year-old HVAC system per Platinum Level agreement. Inspected evaporator coil assembly which showed normal dust accumulation. Discovered significant wall damage with possible mold growth near the air handler and replaced the 20x20x5 filter. Recommended professional remediation for the wall damage and mold issue to prevent system contamination and ensure proper airflow.

Responded to no-heat call for tenant-occupied property with reported non-functioning furnace. Upon arrival, performed complete system diagnostic and discovered tripped circuit breaker at main electrical panel. Reset breaker, verified proper voltage to unit, and confirmed system operation. Cycled system through multiple heating cycles to ensure reliable operation and proper airflow through vents. System is now functioning normally with no additional issues detected.

Performed annual maintenance on 17-year-old system (2nd visit of Platinum plan). Replaced 20x25x5 filter and conducted electrical diagnostics showing 42.6 amp reading on compressor. Inspected wiring connections at control board, confirming proper terminal connections. Customer renewed service agreement.

Responded to service call regarding a hissing noise from master bathroom shower head area. Upon inspection, discovered issue related to water heater connections. Verified the integrity of plumbing system including hot and cold water lines, pressure relief valve, and ventilation components. Made necessary adjustments to eliminate the noise and ensure proper operation of the water heating system.

Completed annual planned maintenance on 10-year-old HVAC system. Verified thermostat functionality and system settings, with particular attention to temperature control parameters. Confirmed equipment levelness using spirit level to ensure proper condensate drainage and optimal operation.

Completed annual planned maintenance on 10-year HVAC system (installed 10/8/25). Performed comprehensive inspection of control board circuitry and verified proper level positioning of equipment. First visit of scheduled maintenance cycle; customer declined service renewal.

Performed diagnostic assessment on unit in response to customer-reported whistling noise during fan operation. Inspected filter alignment as potential cause of issue. CO2 readings were normal. Identified worn blower wheel component that was creating noise during operation; part was removed for inspection. Replaced 20x20x5 and 16x25x5 filters and properly aligned them. System now operating normally with whistling noise eliminated.

Investigated customer's reported HVAC system failure; inspection of blower motor assembly revealed proper connections with all wiring (yellow, red, green, blue, white, and orange) intact to various connection points. System components appear to be in normal working condition with no visible damage or deterioration; further diagnostic testing required to identify the non-visible issue causing system non-operation.

Successfully completed full HVAC system installation, featuring a new Lennox air conditioning unit mounted on concrete pad with proper electrical connections and condensate drainage. Interior components include furnace system with PVC ventilation piping installed in utility room, completing the 3-ton system upgrade as specified in work order.

Performed routine maintenance on two HVAC systems (11 and 16 years old) for Gold Level service customer. Conducted comprehensive diagnostic testing on both furnace units, inspected internal components including circuit boards, wiring connections, and mechanical parts. Replaced 16x25x5 filter and renewed service plan as scheduled for second annual maintenance visit.