HVAC & Indoor Air Quality in Jeffersonville, IN

Completed annual Platinum Level maintenance on a one-year-old single HVAC system during the second visit of the service cycle. Replaced 20x20x1 air filter, performed comprehensive system inspection including airflow verification at supply registers, and documented equipment condition through photographs. Processed membership renewal and collected payment as part of the scheduled maintenance agreement.

Responded to no cooling call on 4-year-old system with no power to thermostat. Diagnosed failed condensate pump in crawlspace preventing system operation. Condensate pump requires replacement to restore cooling functionality; part ordered for follow-up installation estimated at 30 minutes.

Responded to service call for water heater leaking from bottom. Upon inspection, found Bradford White Defender Safety System water heater with active leak at base of tank, indicating internal tank failure. Documented existing installation including gas line connections, copper supply lines, and shut-off valves for service records and replacement recommendations.

Performed monthly maintenance on 2-year-old Gold Level single system. Inspected and replaced dirty pleated air filter (20x25x5) and examined outdoor Lennox condenser unit. Noted customer requires longer hose for proper system cleaning; current hose insufficient for maintenance requirements. Recommended backpack sprayer as alternative solution.

Responded to a gas leak call for a 2010 HVAC system. Upon inspection, identified corrosion at pipe joint connections in the utility room, with visible signs of moisture and deterioration at the copper pipe and fitting assembly. Repaired the faulty connection point that was causing the intermittent gas odor detectable upon entering the room.

Responded to no heat complaint on 3-year-old system under home warranty. Diagnostic testing revealed faulty flame sensor causing system failure. Removed, cleaned, and reinstalled the sensor, restoring proper ignition and heat output. System now functioning correctly with home temperature rising from 63°F toward setpoint of 68°F.

Responded to no-heat call for 1-year-old system with complete shutdown. Diagnosed control board issue indicated by illuminated blue status lights and verified no airflow despite thermostat set to 74°F (home temperature 66°F). Restored system functionality after board replacement and completed full system test to confirm proper operation.

Successfully cleared clogs in both toilets using professional-grade equipment and techniques. Performed thorough inspection of drainage system to ensure complete resolution of the blockage issues.

Responded to second opinion request regarding Bryant furnace (13 years old) with reported CO leak and noise concerns. Performed thorough inspection of the system including furnace, venting, and surrounding mechanical area. Determined that despite the loud whining noise on startup, no active CO leakage was detected during testing, contradicting previous company's assessment recommending full system replacement.

Completed follow-up service call for Job #403113675 to start up the HVAC system and install condensation pump as specified in previous visit. Inspected roof penetrations and verified proper sealing around vent pipes. System is now operational with condensation pump properly installed and connected to the main ductwork system.

Completed planned Gold Level dual system maintenance service, replacing worn copper capacitor and conducting electrical testing with diagnostic equipment. Both systems were thoroughly inspected, with all components functioning within normal parameters after service completion.

Completed annual platinum maintenance service on HVAC system. Performed temperature measurements with digital probe showing 72.9°F reading and inspected interior components including fan motor assembly, electrical connections (red/white/green/orange wires), and gas valve assembly with 94Z identification. System is functioning within normal parameters and service agreement has been renewed for the upcoming year.

Completed monthly Platinum Level maintenance on system, including replacement of 16x20x5 filter which is on a 4-year replacement schedule. Inspected Honeywell ProSeries thermostat operation and verified proper heat function at 69°F setpoint. Checked furnace electrical connections and ignition system, confirming proper igniter glow and flame sequence.

Completed annual maintenance on 6-month-old Platinum Level NSSU system. Performed electrical testing with multimeter to verify proper voltage and amperage readings across components. Inspected and confirmed 16x24x4 filter was in good condition. System is operating within manufacturer specifications; no renewal required at this time.

Completed Platinum Level maintenance on 6-year-old system. Replaced 16x20x1 filter during first annual visit. Inspected plumbing connections, including PVC drainage components, and verified electrical systems using clamp meter which confirmed proper voltage readings of 24.5V to control circuits.

Successfully installed a Generac standby generator system, including mounting the transfer switch with proper emergency disconnect labeling on the home's exterior. Completed all necessary electrical connections between the transfer switch and the main breaker panel, ensuring proper wiring configuration for automatic power transfer during outages.

Completed monthly platinum maintenance service on one CFI system per 2-year contract. Performed diagnostic testing with Fieldpiece meter, recording static pressure readings of 405.1 pascals. Conducted electrical inspection using digital multimeter, confirming proper voltage at 27V. All maintenance procedures completed according to manufacturer specifications.

Responded to customer complaint of loud noise during system startup in 1-year-old HVAC unit. Inspected blower assembly and discovered loose fan mounting hardware causing vibration during operation. Tightened all fasteners on the blower motor and fan assembly, checked electrical connections, and verified proper operation of thermostat controls. System now operating normally with noise issue eliminated.

Completed monthly maintenance service on Lennox HVAC system per Platinum Level agreement. Inspected and serviced the blower motor assembly, examined electrical control compartment including circuit board and connections, and replaced 20x20x5 air filter as scheduled. All components verified in proper working condition with no abnormalities detected.

Diagnosed Lennox HVAC system failure with multiple error codes. Determined blower motor failure as root cause and installed replacement motor. System now operational and customer advised on proper operation of secondary heating until parts fully integrated.