HVAC & Generators in Bardstown, KY

Responded to no-cooling complaint on 6-year-old residential air conditioning system with indoor temperature exceeding 90°F. Upon arrival, performed diagnostic evaluation using digital manifold gauges, which revealed critically low refrigerant pressures (21.1 PSI suction, 23.7 PSI discharge), indicating significant refrigerant loss in the system. Conducted thorough inspection of outdoor condensing unit and identified leak source. Repaired refrigerant leak, evacuated system to remove moisture and contaminants, and recharged unit to manufacturer specifications. Verified proper system operation with thermostat set to cooling mode at 80°F setpoint, confirming adequate airflow and temperature differential. System restored to full cooling capacity for elderly occupants, one with respiratory condition requiring climate-controlled environment.

Responded to no cooling complaint on two-year-old residential HVAC system with water accumulation reported at basement unit. Upon inspection, found significant debris accumulation, dirt, and organic matter inside air handler cabinet affecting system operation. Compressor and refrigerant lines showed proper connections, but interior surfaces displayed moisture-related deterioration and contamination. Outdoor condensing unit positioned on concrete pad with proper refrigerant line connections to building. System required cleaning and drainage assessment to restore proper cooling function and address water discharge issue.

Conducted follow-up site visit to document bathroom conditions and verify accessibility for pending HVAC installation work. Photographed existing bathroom layout, including shower enclosure, flooring, and wall conditions to assess clearances and identify any potential obstacles for equipment placement or ductwork routing.

Installed a new 40-gallon residential water heater in utility room, including proper connection of hot and cold water supply lines with copper piping and flexible connectors. Mounted blue expansion tank near ceiling, integrated all plumbing connections to code specifications, and verified proper operation of all safety features and shut-off valves.

Completed installation of geothermal HVAC system including black air handler unit with integrated components and gray water heater. Connected copper piping with brass fittings and valves between units, installed white PVC condensate drain line, and completed silver reflective ductwork with proper insulation and plenum transitions in mechanical room with tile flooring.

Responded to follow-up service call for system not cooling after previous service visit. Coordinated diagnostic assessment with technical team to evaluate persistent cooling issue and determine appropriate resolution path. Documented existing HVAC system conditions including hydronic heating components, air handler interior showing signs of moisture exposure and corrosion on drain pan, and refrigerant line connections for further diagnostic evaluation.

Completed annual platinum maintenance on a 2-year-old Lennox furnace system, including inspection of all major components and replacement of 20x25x5 filter. Documented system condition with photos showing typical dust accumulation on unit exterior and surrounding utility area, with all mechanical components functioning within normal parameters.

Responded to callback for recurring system leak following previous service visit. Upon arrival, inspected condensate drain system and discovered compromised drain line connections causing water accumulation on concrete floor. Evaluated condensate pump operation and drain pan assembly at air handler base. Identified improper trap configuration and potential blockage in PVC drain lines contributing to overflow condition. Documented water staining patterns on floor indicating ongoing drainage issue. Photographed condensate management system including pump, drain pan, and PVC piping assembly for further assessment and recommended corrective action to resolve persistent leakage problem.

Responded to water leak complaint at basement air handler unit approximately 1.25 years old. Upon arrival, observed active water leakage from base of furnace with saturated air filter and moisture infiltration through middle section of system. Opened lower access panel to inspect evaporator coil assembly and internal components. Identified source of water intrusion affecting refrigerant lines and internal cabinet. Utilized diagnostic equipment to assess system operation and leak origin. Documented internal mechanical components including serpentine refrigerant tubing, electrical connections, and coil assembly condition. System was operational at time of service with airflow present through vents.

Completed monthly platinum-level preventive maintenance on a 2-year-old Coleman HVAC system. Replaced 20x20x1 and 20x20x4 air filters, inspected air handler operation, and verified proper airflow throughout the system. Supply air temperature measured at 74.93°F at floor register, confirming adequate system performance and proper heating operation.

Responded to no cooling complaint on 6-year-old residential air conditioning system with adequate airflow but insufficient cooling. Upon inspection of outdoor condensing unit, diagnosed failed dual-run capacitor preventing compressor from operating properly. Replaced defective capacitor with OEM-equivalent component, verified proper voltage and amperage readings, and tested system operation. Unit now cooling effectively with compressor and condenser fan motor running within manufacturer specifications. Performed complete maintenance service including coil cleaning, refrigerant charge verification, and electrical connection inspection. Advised property owner to maintain clearance around outdoor unit due to excessive vegetation growth observed during service.

Completed comprehensive HVAC replacement estimate for 850 square foot residence requiring 2-ton, 14 SEER air conditioning system with 95-96 AFUE upflow gas furnace and evaporator coil replacement. Inspected existing outdoor condenser unit with visible aging and wear on copper coil components, assessed crawl space conditions revealing moisture concerns and existing ductwork configuration. Documented current system specifications and spatial requirements to provide accurate equipment sizing and installation recommendations for complete system replacement.

Completed routine complimentary air conditioning tune-up on a new system as part of scheduled preventive maintenance campaign. Performed comprehensive electrical inspection including contactor examination and amperage measurements, with all readings within manufacturer specifications. System operating properly with no deficiencies noted.

Completed annual platinum-level preventive maintenance on single HVAC system. Verified thermostat operation showing 68°F set point with cooling mode active to 63°F and 52% humidity level. Measured system amperage at 0.07A using clamp meter on outdoor unit, confirming proper electrical operation. Replaced both air filters per specifications (14x14x1 and 14x30x1). All components inspected and operating within normal parameters.

Responded to service call for leaking garbage disposal with water accumulation under sink. Upon inspection, identified active leak at disposal unit causing water damage to cabinet floor. Removed and replaced faulty garbage disposal unit, reconnected drain lines to existing P-trap assembly, and verified proper seal at all connection points. Tested system for leaks, confirmed proper drainage, and cleaned work area.

# Service Report Responded to no-cool call on 15-year-old residential HVAC system with reported minimal airflow and outdoor unit failure to operate. Upon arrival, performed comprehensive system diagnostic including electrical testing, refrigerant pressure analysis, and airflow assessment. Identified failed compressor contactor preventing outdoor condenser unit from engaging. Replaced defective contactor and verified proper electrical connections throughout system. Inspected condenser coils showing moderate debris accumulation and weathering consistent with system age; cleaned coils to restore optimal heat transfer efficiency. Tested system operation through complete cooling cycle, confirming outdoor unit engagement, proper compressor function, and restored airflow at supply registers. System operating within manufacturer specifications at time of departure. Advised customer of system age and recommended monitoring for future component wear given visible corrosion on refrigerant lines

Performed platinum level maintenance service on outdoor HVAC system, completing second visit of the annual plan. Conducted comprehensive electrical system inspection using Fieldpiece multimeter to test capacitor and circuit board components, and replaced standard CFI filter as scheduled per 2-year maintenance agreement.

Completed Platinum Level maintenance service on a 5-month-old system. Inspected and replaced air filter with proper size, and verified thermostat operation was functioning correctly in cooling mode at 72°F with 67% humidity. System is operating within normal parameters.

Completed Platinum Level maintenance on 6-year-old system with 20x20x5 filter. Performed electrical diagnostics using clamp meter, recording 58.8 amps on primary circuit. Secondary temperature readings measured at 41.1°F, confirming system is operating within manufacturer specifications.

Completed scheduled Platinum Level maintenance service on one HVAC system. Replaced KOCH air filter with new pleated media filter and inspected the control board/power supply module, noting proper connection of all wiring harnesses and verifying integrity of electronic components including transformers and circuit board. System is now operating at optimal efficiency per manufacturer specifications.