Crestwood, KY HVAC & Electrical Services That Get the Job Done Right

Responded to no cooling call on 3-year-old system experiencing short cycling behavior. Upon arrival, verified electrical panel breakers were intact and confirmed air filter had been recently replaced by homeowner. Performed diagnostic testing and measured system parameters, recording temperature differential of 52.5°F at evaporator coil. Identified intermittent system operation where unit would initiate startup sequence then immediately shut down. Diagnosed faulty pressure switch causing safety lockout during compressor startup cycle. Replaced defective pressure switch, tested system through multiple cooling cycles to verify proper operation, and confirmed stable runtime with appropriate temperature split across coil. System restored to normal cooling operation.

Completed platinum level preventive maintenance on 5-year-old HVAC system. Replaced 20x25x1 inch polarized air filter and performed comprehensive system inspection. Conducted electrical diagnostics using digital multimeter, verifying proper voltage and amperage readings across control board and system components. Inspected evaporator coil condition and confirmed adequate airflow through finned surfaces. Examined control board circuitry, toroidal inductors, relay components, and electrical connections for proper operation. All wiring connections secure with no signs of overheating or degradation. System operating within normal parameters with no deficiencies noted.

Responded to no-cooling call on 2-year-old residential system with indoor temperature at 82°F and thermostat set to 72°F. Found outdoor condensing unit completely inoperative with no power to compressor or condenser fan. Performed diagnostic testing on electrical components, checked capacitor values, tested contactor operation, and verified proper voltage at disconnect. Inspected condenser coil condition and cleared vegetation growth around unit perimeter to ensure adequate airflow clearance. Restored system to full operational status with outdoor unit running properly and cooling cycle engaged.

Responded to callback for HVAC system failure following previous service visit. Upon arrival, found outdoor condenser unit and indoor thermostat both operational at time of inspection. Thermostat display showing 65°F setpoint in heating mode with normal functionality. Condenser unit positioned against exterior lattice fence, sitting on concrete pad with protective top grille intact. System appeared to be cycling properly during diagnostic check. Documented equipment condition through photographs for service records. Customer reported system worked approximately one day after initial service call before experiencing repeated failure. Will require continued monitoring to identify intermittent issue causing system shutdown between service visits.

Completed full HVAC system installation featuring a 3-ton 17 SEER air conditioning unit paired with an 80% AFUE gas furnace. Installed new air handler with 16x25x4 media filter cabinet, verified proper airflow and temperature differential across system components reading 68.2°F ambient conditions. Financing arranged with down payment applied, customer protected work area with drop cloths during installation process.

Completed Bronze membership water heater flush service on Rheem Classic Professional tanked unit. Drained sediment from tank bottom, verified proper operation of temperature and pressure relief valve with yellow tag, inspected all copper supply line connections and brass fittings for leaks, and confirmed unit returned to normal operation with no issues observed.

Conducted comprehensive replacement estimate for 27-year-old original HVAC system with uncertain operational status. Evaluated existing outdoor condenser unit positioned on concrete pad near residential structure, assessed electrical disconnect and meter configuration, and documented gas meter assembly for system compatibility requirements. Provided homeowner with complete replacement options and specifications for aging equipment approaching end of service life.

Responded to no-cool condition on 6-year-old residential air conditioning system. Upon arrival, confirmed unit was humming but compressor would not start. Performed diagnostic evaluation of outdoor condenser unit and identified failed dual run capacitor as root cause. Removed access panel, disconnected power, and safely discharged and replaced defective capacitor with proper OEM-rated replacement. Verified all electrical connections, restored power, and tested system operation. Compressor and condenser fan motor started successfully, unit cooling properly with normal amp draw and operating pressures within manufacturer specifications.

Completed Platinum Level planned maintenance on single HVAC system including filter replacement with 20x25x5 media filter as part of second visit on two-year service agreement. Performed comprehensive system diagnostics using digital temperature measurement equipment to verify proper operation of ductwork and air handling components, with all readings confirming system is functioning within normal parameters.

Responded to service call for outdoor unit making unusual noise on 3-year-old system. Upon arrival, performed complete system diagnostic and inspection of outdoor condensing unit to identify source of noise concern. Inspected condenser fan motor, compressor mounting, and all mechanical components for abnormal operation or wear. System was operational with adequate airflow through indoor vents and no ice buildup present at air handler. Checked refrigerant pressures, electrical connections, and contactor operation. Inspected indoor air handler and noted 20x25x5 pleated media filter showing moderate dust accumulation. Verified Lennox thermostat programming and operation, confirming system cycling properly between heating and cooling modes with setpoints at 60°F heat and 68°F cool. Documented filter condition with service date notation for future maintenance tracking. Completed full system evaluation and provided recommendations for continued operation.

Responded to no cooling complaint on 6-year-old residential HVAC system with thermostat set to 68°F but reading 73°F. Upon inspection, discovered heavily restricted airflow due to significant dust and debris accumulation in return air grilles and filter media. Cleaned ventilation registers and replaced clogged air filter, restoring proper airflow to the system. System returned to normal cooling operation with adequate air distribution throughout the home.

Completed Gold Level planned duo maintenance on two 5-year-old HVAC systems, including comprehensive inspection of both indoor and outdoor units, filter replacement with 20x25x5 media filters, and system performance verification. Inspected crawl space and root cellar areas to assess ductwork condition, identifying areas requiring resealing and repair of broken ducts for future service. Both systems operating within normal parameters; documented equipment condition with photos showing outdoor condenser unit and basement mechanical components including condensate drainage and ventilation piping.

Responded to no cooling complaint on 10+ year old system for second opinion evaluation. Previous contractor diagnosed failed compressor. Upon arrival, measured supply air temperature at register showing 53.1°F, indicating system is producing cooled air. Inspected outdoor condensing unit and verified compressor operation, refrigerant lines, and overall system functionality. System found operating within normal parameters with no evidence of compressor failure at time of inspection.

Responded to follow-up service call for outdoor condensing unit producing loud rattling noise during operation following recent motor replacement. Upon arrival, performed thorough inspection of the unit and surrounding components to identify source of abnormal sound. Conducted operational test of the system, verified proper motor function, and checked all mechanical fasteners, fan blade assembly, and cabinet panels for loose hardware or debris that could cause rattling during runtime.

Performed on-site evaluation of existing 15-year-old Trane air conditioning condenser unit and matching furnace system for complete HVAC replacement estimate. Inspected outdoor condenser unit located on brick paver pad against exterior wall, assessed electrical disconnect and utility connections, and documented current system configuration. Evaluated indoor air handler and furnace installation in basement utility area, reviewed existing ductwork connections, and photographed equipment specifications for accurate replacement system sizing and proposal development.

Diagnosed and repaired communication issue on nearly new heat pump system that was preventing heating and cooling operation. Inspection of circuit board revealed loose wire connections at the main control board, which were properly secured and tested. System now communicating properly with all components and functioning at optimal performance.

Performed routine AC tune-up on system of undetermined age. Inspected Honeywell digital thermostat for proper operation with temperature reading at 69°F. Examined air filter which showed normal usage patterns with slight discoloration but remains functional; filter has proper pleating with no significant airflow restrictions.

Completed planned maintenance service on HVAC system according to Platinum Level specifications. Temperature readings were taken at multiple vents, with measurements of 64.9°F and 55.6°F recorded at decorative floor registers. All required maintenance tasks were performed according to scheduled service agreement.

Performed diagnostic testing on 7-month-old system that was not maintaining desired temperature (68°F actual vs. 73°F setpoint). Conducted electrical measurements with Fieldpiece SC260 clamp meter, confirming proper amperage readings of 20.53. System has adequate airflow but requires adjustment to improve heating capacity and performance.

Completed platinum-level maintenance service on 4-year-old HVAC system. Replaced 16x25x1 air filters with new Filtrete filters as part of scheduled second maintenance visit. Performed electrical diagnostic testing on unit with multimeters to verify proper system operation and ensure all components are functioning within manufacturer specifications.